MK-2000 masonry saws on the roll

Words: Bob CoatsThe MK-2000 Series of masonry saws has been designed for high-production cutting. The saws are engineered to cut a variety of masonry types, including cinder block, slump stone block, wall brick, pavers, brick, concrete block and cylinders, roofing tile, marble, granite, decorative rock or almost any other non-ferrous material. They are available with a Honda, Kohler, Vanguard or Subaru engine or electric Baldor 1.5- or two-horsepower motors.

The MK-2000 features an open-back design, which allows for material up to 16 inches long to be cut. The pull-down handle on the cutting head prevents operator fatigue and increases visibility during all cutting operations. Jig-welded, reinforced steel construction, combined with sturdy die cast aluminum uprights, provides positive alignment.

The MK-2000 is designed for use with a 14-inch-diameter segmented wet or dry diamond blade with a .110- to .375-inch cutting width, providing a five-inch depth of cut. The cutting head can be locked in the down position when cutting smaller pieces. It features a spring-assisted cutting head to allow for easier step cutting. The cast aluminum blade guard, with stainless steel water tubes, will not bend or rust. For safety, the stay level blade guard gives 180-degree coverage at all times. Specially located forklift brackets under the frame provide lifting control points for ease of transportation. All saws include a diamond blade, rip guide and water pump.

An optional rolling cart with a rust-resistant, powder-coated finish is inches from the ground, so moving and cutting around the jobsite is fast and easy when setting pavers, stone or brick. The welded frame, with wire mesh decking for easy cleaning, has eight-inch casters and a 38-inch-long handle for easy mobility. The cart has 360-degree swivel casters on the front and locking fixed casters on the rear. The weight capacity of the cart is 1,000 pounds. It cuts down the back labor and work time for installers, so they can get more done in the same amount of time.

For more information visit www.mkdiamond.com.
About: Tools
The Sync Up: Aligning Schedule, Labor, and Logistics in Masonry
July 2026

A masonry contractor is only as good as the crew standing on the staging. You can source the highest-grade block, line up the perfect mix, and have every submittal approved weeks in advance, but production ultimately depends on the stamina, skill, and phy

Shayne Sanders
MAP Partner
Sponsored
Read More
Color Trends Shaping Today’s Masonry Projects
July 2026

Homeowners today are coming into projects with a lot more opinions than they used to have. Between social media, home shows and contractor sites, most customers already have a look in mind before you even quote the job. For masonry contractors, having a

Chad Riley
Stone Savvy
MAP Partner
Read More
The New Equation for Masonry Profit: Predictable Hardware and Proven Data
July 2026

The masonry industry is built on tradition, but modern growth requires a shift from guesswork to absolute certainty. When we talk about the philosophy that you cannot improve what you do not measure, we are looking at the literal minutes and manpower lost

Erin Koets Shayne Sanders
Build Smart
MAP Partner
Read More
Backfill Your Foundation
July 2026

I’ve been noticing an uptick in a very specific kind of application lately, and once you see the pattern, you can’t unsee it. The résumé usually reads like a family photo album. “Started helping my dad when I was 15.” “Worked summers, then full time.” “R

Corey Adams
Building More
Read More