Masonry Magazine December 2010 Page. 19
Kennison
FOREST PRODUCTS, INC.
The Solid Choice for Scaffold Plank
Dense Industrial 65 Solid Sawn Scaffold Plank
Sizes available: 2x10" 2x12"
Lengths: 4'-20'
Z-Plank Laminated Scaffold Plank
Services Available:
Rod-Clip-Brand
End Painting
Precision End Trimming
Paper Wrapping
Meets OSHA/ANSI Standards
Smooth and Rough Surfaces
Call Our Sales Team!
1-888-697-5585
Fax: 337-527-0412
Bob Edens
Sales, ext. 17
Jared Kennison
Sales, ext. 15
Joe Kennison
Sales, ext. 14
www.kennisonforest.com
Call today for delivered prices to your area on partial or full loads!
MCAA
READER SERVICE #144
Krando Metal Products, Inc.
For over 23 years, Krando Metal Products, Inc. has been recognized as a premier supplier of all your construction needs, with all products being manufactured in our 61,000 Sq. Ft. state-of-the-art facility.
One of the many things that Krando Metal has learned is how to separate ourselves from our competitors. In order to do this, we offer short lead times and service that will keep you coming back!
WE OFFER A BROAD LIST OF...
DOWEL CAPS
KEYED FLASHING
TERMINATION BAR
SMOOTH STEP FLASHING
TWO PIECE COUNTER FLASHING
PREFORMED METAL CORNERS & END DAMS
COME CHECK OUT OUR NEW ONLINE ANCHOR ORDERING ON OUR WEBSITE
WE JUST MADE IT THAT MUCH EASIER!!!
KRANDO METAL WOULD LIKE TO WISH YOU AND YOUR COMPANY A SAFE AND HAPPY HOLIDAY SEASON!
www.KRANDO.com
Phone-610-543-4311 Fax-610-543-3799
505 Parkway Broomall, PA 19008
READER SERVICE #191
Flashing
land directly on the jobsite. It is supported by a hands-on representative who can work with the masons to help solve any flashing needs.
Single-wythe through wall flashing in a standard dimensioned CMU wall has been an issue for masons for a while, due to the start-and-stop method of using smaller dimensioned materials turned on end. This method forms a path for the flashing to pass through the wall, using two bed courses, one vertical course apart. The start-and-stop method can potentially create a bond break as the membrane is placed on the CMU directly, with the mortar then placed on top of the membrane to support the following courses. This method also requires the mason to return to the flashing course after the smaller unit (usually only one side) has set, before completing the main body of the wall. Often, it can be weeks before the general contractor is ready for the mason to return, which can create a possibility for water to enter the foundation walls in areas where rainfall is prevalent.
A single-wythe, through-wall flashing alternative is available to the contractors nationally. The product is a drainage pan that sits directly on the standard or decorative CMU and protects each cell individually, using a pitched and insect-protected weep joint. The component bridges the gap between cells and has a removable tab for grouted joints. Simply place the pans on the wall, spread your mortar as you would typically.