Masonry Magazine November 2002 Page. 23
Take normal precautions when handling ceramic glazed brick by wearing approved protective eye wear, gloves and clothing, as directed.
Do not double stack cubes of material. Check delivered units for accuracy. Call before use if you notice any problem or discrepancy. Never touch areas where the ceramic glaze has been broken or chipped to avoid cuts. Sequence material in the order of use at the staging area as it is delivered. Keep units in the factory packaging-in paper trays with dividers-until ready to be placed in the wall by the bricklayer. Do not use brick tongs. Do not pitch or toss units. Stack unused material in a protected area and cover to keep clean and dry.
Preparation for Installation
In addition to the above recommendations: Lay-out units before placing them in the wall. Mark checkpoints every three to four feet to ensure proper joint spacing. Lay out first course without mortar to determine head joints. Avoid cutting when possible. If cut pieces are necessary, try to use at door jambs, corners or non-visible areas.
Installation of Ceramic Glazed Units
Interior construction should be well lit. Do not use metal tools on glazed faces. No glazed faces in the mortar joints unless scored with a saw blade for bonding. Build the corner or lead the same as with face brick. Keep mortar joints uniform at 3/8 inch (or as specified), except for minor variations as required to maintain a bond. Use full, unfurrowed bed and head joints. If you are not sure about a unit, ask before placement. Look for uniform color as you go. Chipped or damaged units should be set aside for use as "cuts" as the job progresses. Cutting, drilling and repairing directions are available from your supplier.
On-Going Maintenance of Installed Units
Use one inch (or larger) non-metallic jointer to strike joints when thumb print hard. After initial set-won't smear condition-clean
MASONRY COMPUTER ESTIMATING
Now in 3D
by Tradesmen's Software
Masonry Computer Estimating That Does It All... in 3D!
See the actual building being displayed in 3D as you do your take-off in either PLAN mode, PERSPECTIVE mode, OUTSIDE mode, INSIDE mode or at any ELEVATION. Complete your take-off, then walk through or around and see the actual finished building(s). SAVE $- No more walls, bandings, openings or even buildings missed from your estimate. Figure special wall shapes like PIERS, GABLE, SLOPE or STEPS! Calculates CMU: HALF and FULL BULLNOSE, DOUBLE BULLNOSE, CHAMFER, or SASH for any or all OPENINGS, JAMBS, CORNERS, CONTROL JOINTS and any SPECIAL CUTS. Integrate with PROJECT COST and DIGITAL PLAN MEASURING SYSTEMS. Windows 95/98/NT/ME or 2000 compatible. 30 day money back guarantee.
Computer illiterate? Let our 40 years of masonry and 10 years of computer experience help you help yourself. Support available 7 days a week.
Tradesmen's Software, Inc. 1-800-494-4899 See for yourself at: www.tradesmens.com