OSHA to Update Construction Industry Standards

Words: Dan KamysOSHA to Update Construction Industry Standards

The Occupational Safety and Health Administration is issuing a Request for Information to initiate the fourth phase of its Standards Improvement Project (SIP). The purpose of SIP-IV is to improve and streamline existing OSHA construction standards by removing or revising requirements that are confusing or outdated, or that duplicate, or are inconsistent with other standards. The agency invites the public, including employers, employees, and employee representatives to submit recommendations for revisions to existing construction standards and the rationale for these recommendations.

 
SIP-IV will focus primarily on OSHA’s construction standards. OSHA began the SIP rulemaking process in 1996 in response to a Presidential memorandum to improve government regulation. The purpose of the regulatory review is to reduce regulatory burden while maintaining or enhancing workers’ safety and health. OSHA published the first SIP rule in 1998. Two additional SIP rulemakings were published in 2005 and 2011. OSHA will review public comments submitted to this notice to determine the need for, and the content of, any subsequent SIP-IV rulemaking.
 
Individuals may submit comments electronically via the Federal eRulemaking Portal at http://www.regulations.gov. Comments may also be submitted by facsimile or mail. See the Federal Register notice for details. Comments must be submitted by Feb. 4, 2013.
Five Truths About Final Brick Cleandown
May 2026

Not all truths are self-evident. Sometimes they’re easy to forget or clouded with misunderstanding. The good news is these truths of final cleandown are not hard to implement on your next project to ensure successfully cleaned and beautiful new brick.

Jake Boyer
MAP Partner
Read More
Shelf Angles and Their Impact on Wall Performance
May 2026

Shelf angles have long been a standard component in masonry construction. Installed at the slab edge, they provide support for brick veneer and are often treated as a routine detail. However, as building performance requirements evolve, particularly aroun

Erica Oliveraz
MAP Partner
Read More
The Mason’s Mark: Defining the Craft Through the Trowel
May 2026

Walk onto any job site, from a custom residential chimney to a sprawling commercial block wall, and you will hear it before you see it: the distinctive ring of high-carbon steel striking masonry. The trowel is more than just a mortar scoop; it is the cond

Mark Maleski
Technical Talks
Read More
Registration Now Open for the 2026 MCAA Midyear Meeting in San Antonio, Texas
May 2026

The Mason Contractors Association of America (MCAA) is thrilled to announce that registration is now open for the highly anticipated 2026 MCAA Midyear Meeting, set to take place in San Antonio, Texas. This exciting event is scheduled from September 13th-1

Industry News
Read More